Quantum LTO-5 HH SAS C, Техническое справочное руководство

Страница: 61 / 118

Chapter 4: Operations
Diagnostic and Maintenance Functions
Quantum LTO-5 HH SAS Model C User’s Guide 55
3 Press and hold the Unload Button for three or more seconds, then
release it to select the function. A flashes in the SCD, followed by 0.
The tape drive erases all errors from the error code log and exits
Maintenance Mode.
Function Code C: Insert
Cartridge into Tape
Drive
This function cannot be selected by itself, but is part of other
maintenance functions (such as Run Tape Drive Diagnostics and Create
FUP Tape) that require a tape cartridge to be inserted.
Function Code E: Test
Cartridge & Media
Approximate Run Time = 15 minutes per loop
Total Number of Loops = 10
Function Code E performs tests that determine whether a suspect
cartridge and its magnetic tape are acceptable.
Press the Unload Button to stop the diagnostic and exit maintenance
mode. Pressing the Unload Button once will abort the test at the end of
the current test loop. Pressing the Unload Button twice will abort the
test immediately. Wait for the drive to rewind the tape and unload the
cartridge.
Caution: When you perform this test, data on the suspect tape will
be overwritten.
Note: If you inserted an invalid tape cartridge (e.g. Gen2 or WORM
media), error code J or 7 appears in the SCD. If you inserted a
write-protected cartridge, or the media has read-only
compatibility (e.g., Gen3 media), error code P appears in the
SCD. In either case, the tape drive unloads the cartridge and
exits Maintenance Mode after the cartridge is removed.
1 Place the drive in Maintenance Mode. For instructions, see Entering
Maintenance Mode on page 45.
2 Press the Unload Button once per second until E appears in the SCD.
(If you cycle past the desired code, press the Unload Button once
per second until the code reappears.)