Step 1: Unpack and Rack the Lattus A10
Installing the Rails and Mounting Brackets
Lattus A10 Access Node Installation Guide
7
Installing the Rails and Mounting Brackets
Note:
Do not switch on power to the rack until instructed to do so.
1
Install the rails in the rack before you install the Lattus A10.
2
After installing rails, attach the mounting brackets to the node
before attaching the node to the rails.
Installing the Lattus A10 Access Node
Before installing the Lattus A10 in the rack, be sure to remove any
protective plastic film that might cover ventilation holes on the
component.
1
Install the Lattus A10 into the rack. The recommended rack location
for the Lattus A10 is at rack positions 27 and 28, above controller
node 3.
2
Apply an identifying label to the Lattus A10 Access Node. (Best
practice is to always apply identifying labels to any installed
component.)