Quantum DXi6902, Руководство по обслуживанию на месте, Страница: 174 / 242

Chapter 3: DXi6902 FRU Removal and Replacement Procedures
Replacing the Node System Board
150 Quantum DXi6902 User’s Guide
Note: Ensure that the cables inside the system are routed along
the chassis wall and secured using the cable securing
bracket.
6 Close the Node cover (see Opening and Closing the Node ).
7 Verify that the DXi6902 BIOS settings are set correctly:
Note: The BIOS is automatically updated to the correct Quantum
version when the system boots up. There is no need to
manually update the BIOS, but you
must
verify that the
BIOS settings are set correctly.
a Turn on the system (see Turning On and Shutting Down the
System on page 21).
b As the system boots, press F2 to display the System Setup
Main Menu .
c Follow the steps described in Required DXi6902 BIOS Settings
on page 204 to verify that all BIOS settings are set to the
Quantum required value, and make any changes as needed.
8 Run Factory Detect Hardware from the Service Menu to detect the
new hardware (see Factory Detect Hardware on page 40).
9 In the remote management console, delete any administrative alerts
and close any service tickets.
Updating the Service Tag and Setting the OEM ID
After replacing the system board, you must install the service tag
(specific to the Node) on the replacement system board. This allows the
DXi6902 software to recognize and display the correct service tag on
the Hardware Status page.
In addition, you must run a utility to update the OEM ID. This correctly
sets the system OEM ID to Quantum.
Before you begin, gather the following requirements:
• Bootable USB flash drive