Initializing the Storage Arrays and Software
Quantum DXi6900-S Installation Guide
37
Figure 28:
Internet Protocol Version 4 (TCP/IPv4) Properties Window
d. Select
Use the following IP addres
s and then enter the following information:
Caution:
Before changing the IP address information, write down the original settings. This
will be used later to reset the network configuration.
l
IP address
- 10.17.21.200
l
Subnet mask
- 255.255.255.0
e. Click
OK
, and then click
Close
.
f. Wait at least two minutes for the computer to set the IP addresses on the local computer.
4. Using a terminal emulation program that supports SSH (like PuTTY), connect to the Node with the
following IP address:
10.17.21.1
The terminal emulation window displays.
5. Enter
ServiceLogin
for the user name and then enter the default service password (Qa@SmX7!).
The command prompt displays.
6. At the command prompt, type the following command and press
<Enter>
:
sudo -i sh
This command creates a shell with root access.
7. At the command prompt, type the following command and press
<Enter>
:
sh /opt/DXi/scripts/service.sh
