Quantum DXi6900-S, Руководство по установке, Страница: 24 / 71

Installing the DXi6900-S System in the Rack
Quantum DXi6900-S Installation Guide 24
Figure 14: DXi6900-S Array or Expansion Module Rails Installation
1
2
3
4
1
2
3
4
Item Description
1 Latches click into place in rack flange (round or square holes).
2 Rail front end.
3 Latch release button.
4 Rail back end.
Installing the DXi6900-S Array or Expansion Module
WARNING: The DXi6900-S Array module and Expansion module (including hard drives) weigh 57
pounds (25.9 kg) and 55 pounds (24.9 kg) respectively. A minimum of two people are required to lift the
chassis.
Caution: Before proceeding, ensure that all hard drive latches are completely closed. Quantum
recommends that you do not remove the hard drives from the chassis. If they have been removed for
any reason during or after the installation, you must install the hard drives in the same position in which
they were removed.
1. Align the Array or Expansion module with the rails, and then slide the module into the rack (see Figure
15 on the next page).
2. Use a 10-32 x 3/4 in. SEM screw with washer at the bottom hole on each side of the Array or Expansion
module’s front panel to secure the module to the rack.