Quantum DXi4701, Руководство пользователя

Страница: 277 / 440

Chapter 9: DXi4701 Configuration
Replication Configuration
Quantum DXi4701 User’s Guide 251
less than the Original Data Size due to the benefits of data
deduplication and compression.
• Average Send Rate - The average send rate (in B/s) of data sent
over the network during replication or failback ( Actual Data Sent
divided by the amount of time required to complete replication or
failback).
You can customize the appearance of the Target DXis list in the
following ways:
• Click the top banner row of the list to collapse or expand the list.
• Click the arrow to the right of a column heading and select
Sort
Ascending or Sort Descending to sort the rows in the table by that
column.
• To show or hide a column, click the arrow to the right of a column
heading, and then click Columns . Select the check box to show a
column, or clear the check box to hide a column.
Note: The statistics in the Target DXis list are for each target DXi
rather than a cumulative total for all targets as is displayed on
the Home page.
Adding a Replication
Target
Add a replication target to configure the DXi4701 to send replicated
data to that target. You can add up to two targets. After you add a
target, you can enable replication to that target for a NAS share or VTL
partition. When replication is enabled for a share or partition, replicated
data is sent to the target system during scheduled or manual
replication.
Note: Before you can add a replication target, you must add the DXi
to the list of allowed replication sources on the target DXi (see
Adding a Replication Source on page 258).
Note: To add a new target when two targets are already configured,
first delete one target (see Deleting a Replication Target on
page 255). Then add the new target.