Installing the DXi4700 System in the Rack
Quantum DXi4700 Installation Guide
44
Figure 32:
DXi4700 Expansion Module Rails Installation
1
2
3
4
1
2
3
4
Item
Description
1
Latches click into place in rack flange (round or square holes).
2
Rail front end.
3
Latch release button.
4
Rail back end.
Installing the DXi4700 Expansion Module
WARNING:
The DXi4700 Expansion module (JBOD, including hard drives) weighs 62.6 pounds (28.4
kg). A minimum of two people are required to lift the chassis. To lift the chassis, use the slots in the
packing foam to place your hands under the sides of the chassis.
Caution:
Before proceeding, ensure that all hard drive latches are completely closed. Quantum
recommends that you do not remove the hard drives from the chassis. If they have been removed for
any reason during or after the installation, you must install the hard drives in the same position in which
they were removed.
1. Align the Expansion module with the rails, and then slide the module into the rack (see
).
2. Tighten the thumbscrews on each side of the Expansion module’s front panel.
