Quantum ATL PowerStor L200 Series, Руководство пользователя

Страница: 95 / 106

Appendix B OCP Error Messages and Error Definitions
ATL PowerStor L200 Series Library User’s Guide 79
Table 28 Library Error
Definitions
Error Code Description
80H
This status indicates no error has occurred.
81H
Invalid command error. This error indicates that the loader received an undefined command
or an invalid parameter to a command.
82H
Undefined error code.
83H
Undefined error code.
84H
A cartridge is in transit after a reset or power up. This error will occur whenever a power-
cycle or reset occurs during a move. The loader controller will insure that the cartridge is
fully loaded onto the elevator and then will proceed with power-on self-tests.
The library controller will be responsible for moving the cartridge either to its home location,
if known, or to the drive before issuing the
EXTENDED SCAN MAGAZINE
command.
85H
Did not find pusher home position during mechanical initialization.
86H
Did not find
PUSHPOS 1
during mechanical initialization.
87H
Time-out while moving a cartridge onto or off of the elevator during mechanical
initialization.
88H
Time-out finding elevator home position during mechanical initialization.
89H
Time-out while attempting to find
PUSHPOS 2
during mechanical initialization.
8AH
Did not leave
DRIVPOS
during mechanical initialization.
8BH
No drive handle installed, or time-out while closing the drives handle during mechanical
initialization.
8CH
Time-out during pusher test - did not leave home position.
8DH
Time-out during pusher test finding pusher home position.
8EH
Time-out during pusher test or during elevator home position leaving pusher home position
while moving, towards
PUSHPOS2
.
8FH
Undefined error code.
90H
No cartridge was present in the drive during a cartridge unload.
91H
Time-out while attempting to find
PUSHPOS 1
(Position in front of the drive before
unloading a cartridge from drive onto the elevator).
92H
Time-out opening drive handle during cartridge unloads.
The library controller determines if the drive is still in unloaded state after receiving this
error code. If the drive is still in the unloaded state, then reissuing the command can retry
the command. If the drive is not still in the unloaded state, then another unload command
must be issued to the drive prior to retrying this command.