9200 Manual Version 1.2 | Quantum Composers
Page 35
:DELay
+/-1000[s]
Sets the delay from the
timing reference to when the
pulse is created. The
command should be sent
without units. If for example
50ns is desired the
parameter sent should be
50e-9, or the decimal
equivalent.
:SYNC
T0,CHA,CHB,CHC
,CHD
Allows the user to select the
timing reference for each
channel.
*Note: Cannot set a channel
to by synced to itself
:MUX
0-15
Decimal representation of a 4
bit binary number (example:
15 = 1111)
:POLarity
NORMal /
COMPlement /
INVerted
Normal is active HIGH,
Inverted and Complement are
active LOW.
:OUTPut
Command to change the
channels’ output parameters.
:AMPLitude
3.3 - 5 [V]
Allows the user to select
adjustable TTL/CMOS output
voltages.
:CMODe
NORMal / SINGle /
BURSt / DCYCle
Allows the user to select the
pattern of outputs to use on
the channel level.
:BCOunter
1 to 1,000,000
When the channel is in Burst
mode will allow user to select
the number of pulses to
output with each input clock
pulse.
*Note: The commas should
be omitted.
:PCOunter
1 to 100,000
When the channel is in duty
cycle mode will allow the
user to select the number of
pulses to create with each
input clock pulse.
*Note: The commas should
be omitted.
:OCOunter
1 to 100,000
When the channel is in duty
cycle mode will allow the
user to select the number of
pulses to suppress with each
input clock pulse.
*Note: The commas should
be omitted.
:WCOunter
0 to 100,000
Allows user to select how
many clock cycles to wait
until the channel should start
creating an output pulse.
*Note: commas should be
omitted.