Qualstar XLS-810160, Руководство по установке

Страница: 176 / 208

13.2 Scanning and Calibrating the Fiducials
13-2 501801 Rev. 07-01-19
13.2 Scanning and Calibrating the Fiducials
Once you have installed the cartridges, you are ready to scan and calibrate the location of
each I/O port, cartridge slot, and tape drive. When you perform a
fidicual scan , the XLS
moves the handler to each cartridge magazine and I/O port and attempts to locate the
fiducial targets, shown in
Figure 13-1 .
It also inserts the calibration cartridge, stored in slot A50, into each tape drive to precisely
locate the tape drive’s position.
To scan and calibrate the fiducials, follow these steps:
1. If necessary, apply power to the library and log in to X-Link. See Section 9.2 on
page 9-3 .
2. If necessary, press the Home button in the upper right corner of any page to
return to the Home page.
Important: A fiducial scan is only required if performing an
upgrade to the library. Upgrades include the addition of
drive bays, I/O Ports, and/or expansion modules (MEM
or POD) to the library.
Installation of single LRM
units do not require a Fiducial scan.
Figure 13-1 Cartridge magazine with two fiducials
Fiducial
Fiducial