background image

PARCEL CHEST ASSEMBLY & INSTALLATION INSTRUCTIONS

Thank you for your purchase of the PARCEL CHEST package delivery system. 

Please read these assembly instructions in full before you begin. A step-by-step 

assembly video is available online. Note, extra screws are included, so you may have 

screws remaining after assembly.
Step 1:   Locate the front, back, sides, bottom and lid (see images below). It is important 

that the bottom is assembled as shown in the photos. If you reverse the bottom, 

the unit will not assemble properly. For best results, assemble the parcel box on 

a level surface.

Step 2:  

To make assembly easier, tap the holes on the inside of all the parts (except 

lid and top of the back panel) using the sheet metal screws. Caution: Do not 

pre-tap the threaded holes located on the lid and the top of the back panel or 

you will strip out the threads. Be careful not to over-tighten the screws. Now 

that the holes are tapped, remove the screws and begin assembly.

Step 3:   Locate the back panel and insert the lip of the back panel under the lip of 

the bottom panel. Make sure the 3 holes in bottom panel line up with the 

holes in the back panel. Insert 3 sheet metal screws and thread them into 

the holes (do not fully tighten the screws). (Figure 1)

Step 4:   Locate the right side panel. Make sure the 2 holes on top of this panel 

are pointed up (if rubber bumper is attached, it should be at the top of this 

panel). Slide the right side panel behind the lip of the back panel and under 

the lip of the bottom panel. Fasten the right side panel to the back panel 

with 5 sheet metal screws (do not fully tighten the screws). Do not fasten the 

right panel to the bottom panel yet. (Figure 2)

Step 5:   Using the same method as Step 4, locate the left side panel and attach it to 

the back panel. (Figure 3)

Step 6:   For this step, a helper is recommended. Locate the front panel. Make sure the 

rectangular hole on top of this panel is pointed up. Spread the left and right 

panels open slightly from the bottom panel. With these panels spread open, 

insert the front panel under the lip of the bottom panel and in behind the left 

and right side panels. Fasten the front panel to the left and right panels with 

10 sheet metal screws (5 screws for each side panel)(do not fully tighten the 

screws). (Figures 4 & 5)

Figure 1

Figure 2

Figure 3

Figure 5

Figure 4

QualArc 

916-273-1576

Fax 916-635-0228

www.qualarc.com

Shim

Sheet Metal 

Screw

1/2" Machine 

Screw

1/4" Machine 

Screw

Masonry 

Anchor Bolt

Отзывы: