Quadro4Li Manual II: Administrator's Guide
Administrator’s Menus
Quadro4Li; (SW Version 5.2.x)
30
The second frame delivers the IP address of the second router and so on and so forth. The results of
Traceroute
are displayed on the lower area of
the page.
Ping
Target
requires the destination (IP address or host name) for the ICMP request.
The
Ping
button starts pinging the specified ping target.
Traceroute
Target
is used to enter the IP address or host name of the destination to be trace routed.
The
Traceroute
button is used to process the router triggering to check the Internet connection.
In the field below these, the output of the Ping or Traceroute procedure is shown.
To Check the Internet connection
1.
Specify the destination address for the ICMP request in the
Ping Target
text field.
2.
Press
the
Ping
button to process the ICMP request.
3.
Specify the destination address to trace the route.
4.
Press
the
Traceroute
button to process the router triggering.
SNMP Settings
The
Simple Network Management Protocol
(SNMP) is an application layer protocol that facilitates the exchange of management information
between network devices and is used by network administrators to manage network performance, find and solve network problems, and plan for
network growth.
On Quadro, SNMP agent is running to allow administrators to remotely manage Quadro’s network and the device’s configuration. Remote
administration is being performed by means of special SNMP monitoring programs (SNMP Manager), which can automatically feedback by the
certainly configured actions on some events on the Quadro or remotely modify Quadro’s settings.
SNMP Settings
page is divided into two pages:
Global SNMP Settings
and
SNMP Trap Settings
.
Global SNMP Settings
are used to enable the SNMP agent on the Quadro, to select the SNMP protocol version for communication with the
administrating application and to define the community for administrating application to connect the Quadro.
Enable SNMP
checkbox is used to enable SNMP agent on the Quadro.
System Location
text field requires optional information to describe the network where SNMP management is performed.
System Contact
text field requires optional information about
the contact person responsible for the SNMP management in
the defined network. Field may indicate the point person’s name,
email address, phone number or other contact information.
Enable SNMP v1 / 2c
checkbox is used to enable SNMP v1/2c
protocol version for the messaging between Quadro’s SNMP
agent and the administrating application. If this checkbox is not
selected,
SNMP v1
will be implied.
SNMP v1 / v2c Read-Only Community
text field is used to
insert the community description (public, private, etc.) for the
read-only management (like gathering information (events,
statistics, etc.) about Quadro’s). Field may contain some kind of
password which should be matching both on Quadro and on the
administrating application for successful SNMP management.
Enable SNMP v1 / 2c Read-Write Access
checkbox
additionally enables a read-write access on the Quadro for the
SNMP monitoring application. With this checkbox enabled,
administrator will be able to remotely configure the Quadro via
SNMP administrating program.
SNMP v1 / v2c Read-Write Community
text field is used to
insert the community description (public, private, etc.) for the
read-write management (like gathering information (events,
statistics, etc.) about Quadro’s and remotely changing Quadro’s
configuration). Field may contain some kind of password which
should be matching both on Quadro and on the administrating
application for successful SNMP management.
Fig. II-50: Global SNMP Settings page
The
Service Restart
button restarts the SNMP sub-system on the Quadro. Restarting the SNMP sub-system is recommended if it does not respond
to a SNMP manager's requests.
