23
7061-196J
April 24, 2019
Explorer II
Figure 23.2
Figure 23.3
The ceramic blanket and both baffle boards
and tube channel assembly can all be
removed at the same time.
Baffle
Baffle
Ceramic Blanket
E. Baffle Board
Figure 23.1
Locknut
Latch Cam
Spacing
Washers
Door Cross
Section
Square Key
Door Handle Shaft
Fiber Handle
D. Door Handle Assembly
Service Part: SRV7063-014
1.
Slide door handle through door.
2.
Install additional washer(s) as shown in
Figure 23.1
3.
Install key in groove.
4.
Align groove in latch cam with key; slide latch cam
over shaft
5.
Install locknut but do not over tighten, the handle needs
to rotate smoothly.
6.
Install fiber handle (
Figure 23.1).
CAUTION
Do not
over tighten lock nut. The door handle needs to
move smoothly.
NOTE:
Tube Channel does not need to be removed to
replace the baffles.
Service Part: SRV7061-160
1.
Remove all ash from the firebox, and extinguish all hot
embers before disposal into a metal container.
2.
The baffle board has 2 pieces. With the ceramic
blanket still in place, slide one baffle piece over the
top of other one and pull out top piece through the
door opening and then remove bottom baffle piece
(
Figure 23.2).
3.
Remove the ceramic blanket.
4.
Re-install the baffle pieces one piece at a time. Be
sure the baffle boards are even with the front manifold
tube and is resting on all tubes (
See page 14).
5.
To re-install the ceramic blanket, it is easier to fold it
in half first. Place on top of baffle board, open up and
flatten and smooth out the blanket. Re-check the baffle
board for correct positioning (
Figure 23.3).
