Page 16
7022-122D
May 12, 2014
Castile Pellet Insert
C. Full Reline With Vertical Outside Air
Figure 16.1
Outside Air
Termination
at
Chimney Top
12” (305mm)
min. below
12” (305mm)
min. above
NOTE; Use metal
plate around
exhaust vent pipe
and seal all edges
with non-flammable
insulation such as
mineral wool or
ceramic.
Do not use high
temperature caulk-
ing materials to seal
any edge to prevent
future serviceability
NOTE:
Check clearances carefully for this type of
installation to ensure adequate room for outside air
venting.
Check building codes prior to installation.
• Installation MUST comply with local, regional, state and
national codes and regulations.
• Consult local building, fi re offi cials or authorities having
jurisdiction about restrictions, installation inspection,
and permits.
CAUTION
NOTE:
In Canada, only a full reline is allowed per
ULC S628-93, ORD ULC C1482-M1990.
NOTE:
In Canada this fi replace insert must be installed
with a continous chimney liner of 6 inch (152mm) in
diameter extending from the fi replace insert to the top
of the chimney. The chimney liner must conform to the
Class 3 requirments of CAN/ULC-S635, Standard for
Lining Systems for Existing Masonry or Factory-Built
Chimneys and Vents, or CAN/ULC-S640, Standard for
Lining Systems for New Masonry Chimneys.
