quadient DS-200iQ, Руководство пользователя, Страница: 56 / 130

50
JUN 2020
USER GUIDE
4 OPERATOR IMOS SETTINGS DS-200iQ / DS-600iQ
REV 00
4.6 OUTPUT PLACEMENT
Output placement settings allow the operator to select a different exit instead of the
default (if other exits are fitted).
An exit may be an Output Conveyor, or Catch bin.
1. To change the output placement, select any exit or mail sort, as shown in
Figure 4.24, then select the required exit or mail sort to change it.
QTL-RND-SCR-00000083-A-00
Figure 4.24 – Output placement
2. To revert back to the default settings, press ‘ Auto place mail sorts ’.
3. Press ‘ Next ’ once the desired settings have been made.
4.7 OUTPUT SETTINGS
Output settings control how certain outputs are used, whether by an Output Conveyor,
Turner, Franker, Printer, or a combination of these depending on the units installed and
configured within IMOS hardware units setup.
1. First select the output exit (e.g. Exit 1, Exit 2, or Exit 3) to be used for the output
setting, set batching to ‘ Batch On ’ and then press ‘ Ok ’ as shown in Figure 4.25.
QTL-RND-SCR-00000084-A-00
Figure 4.25 – Output batch settings
The Batch mode must also be set with the following options available:
▪ Stop - When the batch quantity is reached, the machine will stop until the
‘ Run ’ button is pressed to run another batch
▪ Continue - When the batch quantity is reached, the machine will pause for the
specified ‘ Batch complete pause time ’ and then resume running
NOTE:
The Conveyor will continue to run.