quadient DS-200iQ, Руководство пользователя, Страница: 49 / 130

43
JUN 2020
USER GUIDE
4 OPERATOR IMOS SETTINGS DS-200iQ / DS-600iQ
REV 00
NOTE:
Label positions specified in ‘ Region of Interest ’ are relative to the top left-
hand corner of the document ‘ Print orientation ’ (i.e. Portrait or Landscape)
selected within the New-Document screen.
9. Select the Detection Mode when viewed as read.
a. If ‘ Auto ’ Detection Mode is selected, you will be prompted to indicate
which side of the paper width the label is located - its position will
then be automatically detected.
NOTE:
‘ Auto ’ Detection mode is not available for OMR.
b. If ‘ Manual ’ is selected, enter the label size and position.
10. Turn Off edge detection if coloured or densely printed paper is giving false
readings.
11. Press ‘ Ok ’ once the Region of Interest settings are complete.
12. If ‘ Doc Id mode ’ is to be used, select ‘ On ’. This reads a label character and
compares its string value with the string entered in ‘ Doc Id ’ to confirm that the
correct document type is used.
13. Press ‘ Save ’ once the desired settings have been made.
For further assistance on BCR definitions and OMR definitions, see
section 8.7 Reading Specifications
Users with appropriate access rights can also create Documents
(following the same procedures), from the Libraries within the
Menu Screen.
4.2.5 ENCLOSURE MAILSET
1. To select an existing enclosure for the mailset, press ‘ Select ’ to choose an
enclosure type from the library, then select the required document from the
list and press ‘ OK ’ as shown in Figure 4.13.
QTL-RND-SCR-00000074-A-00
Figure 4.13 – Defining the enclosure type
The remainder of the setup process for Enclosures is the same as Documents, see
section 4.2.3 Document Mailset for further assistance.
2. Press ‘ Next ’ once the desired settings have been made.
4.2.6 CREATING A NEW ENCLOSURE
The creation process for new Enclosures is the same as new Documents, see section
4.2.4 Creating a New Document for further assistance.