Installation Manual
4. Power on and Run Router
40
www.qtech.ru
Check after Power on
Power on the router. After loading all cards, check as follows to ensure that the later
configuration work can be done normally:
After the router is powered on, the ventilation system works, and check whether there is the
sound of the fan rotation and whether there is air discharged from the ventilation holes of
the router.
View whether the indicators on the router are normal.
Table 4-1 The indicator status when the router works normally
Indicator Name
Indicator Color
Description
SYS
Green
Quickly flash: indicates that the board is in
bootloader loading or IOS loading state
(flash frequency 5Hz)
on: the status before IOS loading and after
bootloader starts successfully
Slowly flash: IOS loaded successfully
(frequency 0.5Hz)
off: not powered on
PWR
Green
On: Indicate that the system power status is
normal
FAN
Green
On: Indicates that the system fan status is
normal
Access Network
Access Network via Ethernet Twisted Pair
The 10/100/1000Base-T electrical interface of the router adopts the RJ-45 connector. The port
supports MDI/MDIX auto-sensing and adopts class-5 or above twisted-pair to connect the
network.
Connection steps:
Step 1:
Insert one side of the Ethernet twisted pair to the Ethernet electrical interface
of the router (RJ-45 port).
Step 2:
Insert the other side of the Ethernet twisted pair to the RJ-45 port of the device
connected to the network.