Installation Manual
3. Router Installation
30
www.qtech.ru
Step 3:
According to the description on the port lightning protector specification, use
the network port conversion cable to connect the port lightning protector (Pay
attention to the connection direction and note that the external cable is
connected to the IN end and the conversion cable on the router is connected
to the OUT end). At the same time, observe whether the indicators on the
boards are normal.
Step 4:
Bind the cables tidily using cable ties.
The port lightning protector is not provided with the router. The user can
purchase it as required.
The port lightning protector aims for the Ethernet port of the
10/100/1000M electrical interface using the RJ-45 connector.
The port lightning protector specifications contain the technical
parameters and the installation and maintenance instruction of the surge
protector. Refer to the specifications carefully in the actual installation.
Avoid the installation direction of the port lightning protector is connected
reversely. The external cable is connected to the IN end and the router
network port is connected to the OUT end.
Avoid the port lightning protector is improperly grounded. When installing
the PE of the surge protector, keep the PE as short as possible to ensure
the well contact with the router ground terminal. After the connection is
finished, use a multimeter to check the connection.
Avoid that the port lightning protector is incompletely installed. When
there is more than one outbound network port of interconnected cable
between the router and other router, install the lightning protector for all
cable outbound network ports.
Install Power Supply
Installation Preparations
Take out the power module from the packing box and keep the accessories in the box.
Confirm that the power module switch is in "off" state before installation.