NETQ-6000
quick installation manual bridge-repeater
11
corresponding cable interface light is light? If only sometimes lighting doesn’t mean
the networking cable is connected..
Please run the ping in the command prompt to verify the network connection
between your PC(s) and the router. LAN Interface with IP address 192.168.2.1
If yes, then check your browser, whether it sets up surfing via a proxy server, if
without, please don't do that.
If no, you can hold “RESET” with 7 seconds to restore factory settings and try to
ping 192.168.2.1 to see if it can be verified
If failed again, please call our technical support hot line.
2
、
If forget the enter password of the router setting page and can not access it, how
to solve it??
Please restore factory settings. The way is to hold” RESET” button with 15
seconds.
3
、
How to deal with the problem of IP address confliction when computer
connected with router?
Pls check is there any other DHCP server in LAN, if yes, pls close it.
The router’s original IP address is 192.168.1.1, pls make sure this IP address is
different from other local networking. If same, pls change one. If the IP address is
same in two different computers , pls change one to make them different.
How to access the internet for the dynamic IP users?
Enter into the router’s management interface, and set it as Dynamic IP in internet
settings, then save.
Some ISPs binding th
e MAC address to computer’s LAN Card, you should copy
the router’s MAC address on this condition.
The way of copy MAC address is as below:
Pls click “Advanced Settings” and choose “ MAC Clong”, input the MAC Address
which is Limit to computer’s Lan Card, click “save” after that.