8
TD-000508 -01 -A
Free-Standing Installation
1. Perform the steps in “Prepare for Installation (both options)” on page 6.
Refer to
Figure 11
2. Remove the Cable Cover (2) from the TSC-7t (1).
Refer to
Figure 12
3. Connect the cables to the proper connectors in the TSC-7t
a. LAN A/PoE - required for network. (PoE is optional if you use the 12V DC AUX Power)
b. LAN B - optional (for redundant network)
c. 12V DC AUX Power input - optional (required if you are not using PoE)
4. Carefully route the cables as shown.
NOTE:
Some cables may have a protective boot over the RJ45 connector. The boots may not fi t into the TSC-7t cable cavity.
Refer to
Figure 13
5. Carefully place the Base (1) onto the TSC-7t body (2). Make sure the cables are not pinched.
6. Secure the Base to the TSC-7t with the 4 screws (3) removed in “Prepare for Installation (both options)”.
USB
Refer to
Figure 14
(1)
USB 2.0 Micro-AB interface
— Figure 11 —
1
2
— Figure 12 —
12V DC
RESET
LAB B
LAB A / PoE
— Figure 13 —
2
1
3
— Figure 14 —
1
