QSC, LLC 2020
2.1– Mounting
A typical installation will involve mounting the wall plate
into a pre mounted wall box or mounting bracket. Before
installation, make sure the wall box where the D2i is to be
installed is pre-wired with a suitable cable back to a PoE-
enabled network switch or mid-span injector. If a mid-span
injector is being used, the cable should be connected to the
port that supplies both Ethernet and power (refer to the
devices manual if unsure which port is which).
Attach the network cable from the switch/mid-span injector
to the Ethernet port of the D2i. If the switch or mid-span
injector is already running and PoE is enabled, the unit will
power up and the green status LED on the front of the device
will turn on.
If using with an Axiom expansion device, a second suitable
cable must also be installed and attached to the Axiom port
on the D2i and connected Axiom device. Refer to the
connected Axiom device manual to insure proper
configuration for daisy-chaining.
With the cable(s) attached, carefully place the D2i into the
wall box taking care to not trap the cabling. Once in place,
secure it with the screws provided. Once the unit is secured
in the wall box, fit the Decora plate and secure it with the
screws provided.
The D2i comes in a single gang US Decora style form factor
and may be mounted in most US single old and new work
back boxes and mud-rings. Given the single gang size, the
D2i may be mounted in larger gang boxes with other single
gang form factor products to provide flexible AV system
modularity where needed.
*Note:
CAD drawings can be downloaded from the QSC
website. Please contact QSC for any further product
related information that is not accessible on the website.
Figure 4- Dimensional Drawing
