QNAP TS-110, Руководство пользователя программного обеспечения

Страница: 104 / 369

104
4.5 Hardware
Go to "Control Panel" > "System Settings" > "Hardware" to configure the NAS hardware
functions.
Ge ne ra l
E na ble c onfigura tion re s e t s witc h: When this is enabled, you can press the reset
button for 3 seconds to reset the administrator password and the system settings
to default (NAS data will be retained) or 10 seconds for advanced system reset.
o
B a s ic s y s te m re s e t: You will hear a beep after pressing and holding the reset
button. The following settings will be reset to default:
System administration password: admin.
TCP/IP configuration: Obtain IP address settings automatically via DHCP.
TCP/IP configuration: Disables Jumbo Frames.
TCP/IP configuration: If port trunking is enabled, the port trunking mode will
be reset to "Active Backup (Failover)".
System port: 8080 (system service port.)
Security level: Low (Allows all connections.)
LCD panel password: (blank); this feature is only for NAS models with LCD
panels.
VLAN will be disabled.
Service binding: All NAS services will be run on all available network