4. Click .
The Edit Group window opens.
5. Configure the group settings.
Setting
Description
Mode
Controls the link aggregation mode for the group
• LACP: Provides automatic failover and dynamic configuration
• Static: Aggregates all configurations at once on the selected link
aggregation ports
Important
Enable Link Aggregation before connecting cables to
the switch to avoid creating a data loop.
Port Configuration
Specifies which ports are included in the group
Note
Ensure that you configure the same settings for all the
member ports in a LAG.
6. Click Save.
QSS updates the group settings.
Note
When assigning a LAG to a VLAN, QNAP recommends removing individual LAG port
members from the VLAN, and then adding the entire group to the VLAN as required. If
individual port members are not removed, the VLAN is reset to its default settings.
Managing Rapid Spanning Tree Protocol (RSTP) Settings
RSTP provides rapid convergence of the spanning tree and builds a loop-free topology for the switch
network. RSTP allows you to enable backup links in case an active link fails.
Note
• RSTP is disabled by default.
• The default bridge priority for the switch is 32768.
Configuring the RSTP Settings
1. Log in to QSS.
2. Go to Configuration > RSTP .
3. Change the RSTP control status.
Toggle Setting
Description
Click to enable the RSTP function.
Click to disable the RSTP function.
QSW-M2106 User Guide
QSS
18
