QMS QDOC, Руководство пользователя

Страница: 125 / 172

7URXEOHVKRRWLQJ
WKH406
3ULQW6\VWHP
7URXEOHVKRRWLQJ
6HUYLFH0HVVDJHV
When the QMS QDOC Bookletmaking System requires service, oper-
ation stops, and the QMS 4060 Print System message window dis-
plays
CALL FOR SERVICE
followed by the location of the problem
and an error number. See “Placing a Service Call” on page 6-17 for
other information that you may need to have available when calling
your QMS vendor for service.
3DSHU-DPV
See chapter 6, “Troubleshooting,” of the QMS 4060 Print System
Operations Manual, for information on removing QMS 4060 Print Sys-
tem paper jams.
FINISHER JAM
A paper jam
occurred in either the
Folder/Stapler or the
Trimmer. Locate and remove
the jam. See
“Clearing paper
Jams” on page 6-5.
OUT OF STAPLES
The Folder/Stapler
has run out of
staples. Refill the Stapler.
See the “Operating
the Folder/Stapler,”
section of chapter 3
for instructions.
SIZE>MAX
If you send a print
job of more than 88
pages to the QMS
QDOC
Bookletmaking
System while it’s in
booklet mode, the
system goes into a
“wait state.” Manually delete the
print job from the
print queue using the
Cancel key on the
QMS 4060 control
panel to return the
system to an active
state.
This status message... means... do this...