QMS Magicolor, Руководство пользователя

Страница: 201 / 446

CAUTION: Never force a toner cartridge onto the wrong developer
cartridge. This can damage the cartridges and the printer.
6. Lower the toner cartridge until it fits firmly onto the notches
on the developer cartridge.
7. Press the top of the toner cartridge until it snaps into place
under the two securing latches.
8. Grasp the tab on the top of the toner cartridge.
9. Holding the toner cartridge in place, pull the tab and attached
clear tape straight up and completely out of the cartridge (fig.
2.12). Then discard the tape.
10. Set the print density dial (fig. 5.6) for the changed toner
cartridge in the center if necessary.
11. Replace the printer’s top cover.
Replacing a Developer Cartridge
A message on the control panel window, X DEV LOW indicates
when it is time to change a developer cartridge. The x indicates
which color should be changed. Cyan, yellow, and magenta
developer cartridges last for approximately 15,000 pages, and
black developer cartridges last for approximately 30,000 pages.
NOTE: The industry standard for developer measurement is
quoted at 5% coverage for letter- or A4-size media.
To replace a developer cartridge, use the following procedure:
1. Remove the printer’s top cover (fig. 2.5).
2. Remove the toner cartridge by holding it across the center,
squeezing the sides to loosen the pins on the back side from
the developer cartridge notches (fig. 6.1). Then, lift the toner
cartridge straight up and out of the printer.
Chapter 6
C o n s u m a b l e s a n d P r e v e n t a t i v e M a i n t e n a n c e 6 - 7