QMS Magicolor 6100, Руководство по эксплуатации

Страница: 74 / 224

2"*0F$G
'
To improve collation performance, which allows you to collate longer and more com-
plex print jobs on your printer, you can do one of the following:
Add more printer memory, which automatically increases the display list client’s
memory settings.
Take any memory not being used by other clients, and add it to the Administration/
Memory/Manual Config K Mem Display memory setting.
Caution: Use this option only if you’re familiar with adjusting memory clients’
values. (Refer to chapter 2, “Printer Configuration,” in the Reference manual for
information.) Incorrect use of this option could cause your system to operate
incorrectly.
If your printer has an optional hard disk, set the Administration/Memory/Enable
Disk Swap menu to On. This distributes any extra memory to all clients.
Collate through your application.
» Note: Collating through your application is more time consuming than collating
through the printer. The application sends the complete job the requested number
of times rather than sending it once and holding data in printer memory.
2"*0F$G
."*2"*0
If you don’t have an automatic duplexing option, you can duplex print manually: Print
on one side of the paper, reinsert the printed sheet(s) into the media cassette (blank
side up), and then print the second side.
» Note: Media jams may occur if the printed sheet(s) reinserted in the media cassette
are not entirely flat.
" 2"*0
2-sided (duplex) printing can be done automatically with the optional duplexer
installed. There is no need to manually reinsert the paper.