QMS Magicolor 6100, Руководство по эксплуатации

Страница: 175 / 224

*
!*
+"!*
'9
puter, and your software application the same? See chapter 2, “Printer
Configuration,” in the
Reference
manual.
If you still cannot identify the problem, contact your QMS vendor.
4 Is the printer printing codes or not printing at all when in ESP mode?
Reconfigure the port to the specific printer emulation of the file you are
trying to print. See chapter 2, “Printer Configuration,” in the
Reference
manual for instructions.
If a PostScript file prints PostScript statements while the printer is in ESP
mode, increase the ESP timeout. See chapter 2, “Printer Configuration,”
in the
Reference
manual for instructions.
If you continue to have problems with the ESP mode selecting the appro-
priate printer emulation, contact Support. Refer to appendix A, “QMS
Customer Support.”
* !*
The OPC belt is extremely sensitive to bright light and direct sunlight. Always leave it
in its protective bag until you are ready to install it. Any exposure to light should be lim-
ited to two minutes. If you suspect the belt is damaged due to exposure to light, put
the belt in a dark place to recover. Depending on the amount of exposure, recovery
may take up to two hours. Recovery time is dependent on the amount of exposure
sustained, and recovery is not guaranteed.
**!*
2 / ;
If the printer has warmed up and the Data indicator stays on, two problems may exist.
If you are downloading additional typefaces, too many can overload the printer’s
memory, causing the printer to reset and lose information previously downloaded to
RAM. Make sure you have enough printer memory.