QMS Magicolor 2 Desklaser, Инструкция по установке

Страница: 45 / 60

++/)
%
#
c Send request timeout
Sets the amount of time that the QMS Network Print Monitor waits for a print
job to be sent before it returns control to the Microsoft Windows 95/98 Print
Spooler. Scroll through the list box and select a value between 1 and 600 min-
utes. The default is 60 minutes.
8 Configure the audible alert.
This setting enables the QMS Network Print Monitor’s problem alert sound. Click
the Audible Alert check box to have the monitor beep the system speaker when it
encounters an error writing to the QMS port. Clear the check box to disable the
problem alert sound.
9 Choose OK.
10 Close the Print Servers Properties dialog box.
) 0123
» Note:
If you’re using Windows 95/98, refer to the installation instructions on page 34.
The QMS Network Print Monitor is installed on your Microsoft Windows NT worksta-
tion or server. There are two different methods for installing the QMS Network Print
Monitor, depending on whether you’re performing a new installation or upgrading an
existing installation. Both methods are described here.
—
» Note: You must be logged on as a member of the Administrator group to install the
QMS Network Print Monitor. Also, the TCP/IP network software must be installed.
If this timeout expires
and the job was sent
via a... This is what happens...
Windows 95/98 host The print job is automatically terminated and
cleared from the system.
Workstation The Windows 95/98 Print Spooler dialog box
displays, asking for a retry or cancel response.
» Note: Regardless of your response, the job is
terminated and cleared from the system.