QMS 860, Руководство пользователя, Страница: 350 / 398

Stand-Alone PC
1. Set the end job mode from the printer’s control panel.
2. Add the EOD command to your file.
NOTE: If using steps 1 and 2 are not feasible in your stand-alone
PC environment, you can alternatively use a program that
either causes an emulation timeout or that inserts an EOD
command between each print job. See your QMS vendor
for more information on this type of program.
PC Print Server
1. Set the end job mode from the printer’s control panel.
2. Create a job separator to append an EOD command and send
it between each print job.
Other Print Queuing Systems
If you use a print queuing system other than a PC print server and
you experience what appears to be an EOD command problem, you
may need to use another procedure, such as a print utility, an
initialization sequence, or a header page to add an EOD command.
See your print queuing system documentation, your network
administrator, or your QMS vendor for more information.
How to Set the End Job Mode via the Control Panel
Use the following procedure to set the end job mode from the
printer’s control panel for printers connected via the serial or
parallel interface to a stand-alone PC, a PC print server, or some
other type of print queuing system:
Appendix F
F - 2 2 A d d i t i o n a l T e c h n i c a l I n f o r m a t i o n