QMS 2060, Справочник

Страница: 91 / 210

0HPRU\
3ULQWHU&RQILJXUDWLRQ
(PXODWLRQ
The K Mem Emulation, listed on the status page as Emulation, is the
number of kilobytes of RAM to be used by non-PostScript emulations
for temporary storage and for loading optional emulations.
Notes This memory setting can reduce the number of times a
PostScript font must be converted from outline form to bitmap
form, thus reducing processing time. On the other hand, it can
increase the length of time the font cache must be searched,
thus increasing processing time. The maximum value listed
depends on the amount of memory installed and if a hard disk
is present.
If you change the K Mem for PS Fonts value, the printer
automatically restarts after you save your changes and exit
from the Configuration menu.
Menu Administration/Memory/Manual Config/K Mem Emulation
Choices 01024-no maximum
Notes If you receive an emulation error, you may need to increase
the amount of memory for this client.The maximum value
listed depends on the amount of memory installed and if a
hard disk is present.
QMS recommends that you should add at least 1MB of
physical RAM to your printer and increase this memory client
by 1 MB. If the Enable Disk Swap option is turned on, then
you can increase the emulation memory client using this
memory. Failure to add memory to this client may prevent the
printer from loading and using the emulation. Check the
documentation included with the loadable emulation for
information on additional resources requirements.
If you change the K Mem Emulation value, the printer
automatically restarts after you save your changes and exit
from the configuration menu.