QMS 2060, Справочник

Страница: 89 / 210

0HPRU\
3ULQWHU&RQILJXUDWLRQ
0DQXDO&RQILJXUDWLRQ0HQX
The manual configuration menu allows you to adjust memory clients
based on your printing needs.
&RQILJXULQJ6SRROLQJ
The K Mem for Spool, listed on the status page as Host Input, is the
total number of kilobytes of RAM allocated to all spooling buffers. This
memory client stores incoming data from the various interfaces until it
is processed and printed.
When the sum of the Min K Spool for all interfaces is less than K Mem
for Spool, memory is allocated as follows:
1 Interfaces with Min K Spool (in the Administration/Communica-
tions menu) value greater than zero receive their specified alloca-
tion.
Default On
Notes If disk swapping is enabled and the hard disk is removed or
not turned on, the printer will automatically reset to the factory
defaults.
The printer must be restarted for changes to the Enable Disk
Swap and other memory menus to take effect. You can either
let the printer restart automatically after you save the change
and exit from the Configuration menu, or you can wait for the
change to take effect the next time you manually turn on the
printer.
Menu Administration/Memory/Manual Config/K Mem for Spool
Choices 00128-30720
Notes This value must be greater than the sum of the Min K Spool
for all installed and enabled interfaces. The maximum value
listed depends on the amount of memory installed and if a
disk drive is present.
If you change the K Mem for Spool value, the printer
automatically restarts after you save your changes and exit
from the configuration menu.