QMS 1660, Операция

Страница: 46 / 122

Introduction
QMS 1660 Print System Operation 4-2
Introduction
Blurred or splotchy prints and paper jams can result from dusty printer
parts. Regular cleaning takes only a few minutes and helps ensure
print quality.
This chapter describes how to handle and clean the printer.
Handling the Printer
Handle the printer with care to preserve its appearance and to ensure
maximum performance. Abuse may cause damage. Keep the follow-
ing guidelines in mind:
n
Do not place anything on the top of the printer.
n
Do not place anything on the multipurpose tray except the media
being used for printing.
n
Do not leave the printer open for any length of time, especially in
well-lit places; light may damage the toner cartridge.
n
Wait until the printer has cooled down before covering it with a
dust cover.
n
Lift the printer from the bottom only. Make sure two people are
available to lift the printer when moving it.
n
Keep media in the output tray at minimum level. If media stacks
too high, media may jam or curl.
n
Do not attempt to lubricate or disassemble the printer.
n
Store the printer under the following conditions when it’s not
going to be used for an extended period:
- Unplug the printer.
- See the “Environmental Requirements” section of appendix
B, “Technical Specifications,” in the
Reference , for storage
specifications.