3–Fibre Channel Configuration
Configuring Boot Devices
45
BK3254601-00 C
Configuring Persistent Binding with Interactive
QConvergeConsole CLI
To bind a target using interactive QConvergeConsole CLI:
1.
On the
Fibre Channel Adapter Configuration
menu, select
Target
Persistent Bindings
.
2.
On the port menu, select a port and then select
Bind Target(s)
to bind a
target to a port.
3.
Select a target and specify a target ID to open the
Target Persistent
Binding – FC Port Configuration
menu with options to select more targets,
save changes, or cancel the binding operation.
For more information, refer to the section about Fibre Channel interactive
commands in the
User’s Guide—QConvergeConsole CLI
(part number
SN0054667-00).
Configuring Persistent Binding with Noninteractive
QConvergeConsole CLI
To bind a selected target to a specific adapter using the noninteractive mode of
QConvergeConsole CLI, issue the following command:
#
qaucli -pr fc -p (<hba instance> | <hba wwpn>) (<target wwnn>
<target wwpn> <target port id> <target id>)
Where:
For more information, refer to the section about Fibre Channel noninteractive
commands in the
User’s Guide—QConvergeConsole CLI
(part number
SN0054667-00).
Configuring Boot Devices
Use QConvergeConsole or
Fast!
UTIL to configure boot devices:
Configuring Boot Devices with QConvergeConsole GUI
Configuring Boot Devices with Interactive QConvergeConsole CLI
hba instance
= Adapter number (use the
-g
command to find)
hba wwnn
= Worldwide node name of the adapter
hba wwpn
= Worldwide port name of the adapter
target wwnn
= Worldwide node name of the target
target wwpn
= Worldwide port name of the target
target port id
= Port ID of the target
target id
= ID to which the target is bound
