Qlogic QLA200 HBA, Руководство пользователя

Страница: 33 / 54

FL0054601-00 B 5-1
Section 5
NetWare Driver Installation
5.1
Introduction
This section provides instructions for installing QLogic drivers on a NetWare 5. x or
6. x operating system (OS).
5.2
Finding the Driver Files
The NetWare driver files are located on the SANsurfer QLA200 (CD) and on the
QLogic web site. Be sure to check the QLogic web site for the most up-to-date
version of the driver. This section describes how to download the driver from the
QLogic web page or the SANsurfer Fibre Channel HBA Software CD to a floppy
disk (disk).
During Netware OS installation, the driver must be on a disk, since
you cannot swap CDs during the installation.
Follow these steps to download the driver from the QLogic web page or the
SANsurfer Fibre Channel HBA Software CD to a disk for installation:
Step 1. Do one of the following:
❑
Locate the driver you want on the QLogic web site ( support.qlogic.com )
and click Download .
❑
From the SANsurfer Fibre Channel HBA Software CD home page, click
Driver and Application . In the table titled 2Gb FC - QLA200 Series ,
locate the Operating System column. Click NetWare . The SANblade
Fibre Channel HBA Software and Drivers screen displays. Click
Download .
Step 2. If prompted Would you like to open the file or save it to your computer?,
click Save . Specify a temporary location on the hard drive and download
the self-extracting file.
Step 3. Insert a disk in an appropriate drive.
Step 4. Run the self-extracting file you just downloaded. Extract the files to the
following directory on the disk:
A:\NWUPDATE\DRIVERS
After the file has extracted, verify that the QL2300.HAM and QL2300.DDI
files are in the \NWUPDATE\DRIVERS directory.
Step 5. Remove the disk and take it to the NetWare server.
NOTE