Qlogic QConvergeConsole CLI 2400 Series, Руководство пользователя

Страница: 129 / 366

6–iSCSI Noninteractive Commands
-rwt (Perform Read/Write Buffer Test)
SN0054667-00 C 6-23
-rwt
(Perform Read/Write Buffer Test
)
The read/write buffer test writes an 8- or 16-byte pattern to the disk’s buffer and
reads the written buffer back. It is nondestructive to disk data.
To do a read/write buffer test, issue the
-rwt
command as follows:
-rwt < hba_port_inst> [-STOP] [-RWPAT n ] [-CNT < Test Count> ]
Where:
To continue, press ENTER.
-save
(Save Host Configuration)
To save the configuration (in XML) of all adapters detected, issue the
-save
command as follows:
-save < file_name >
CAUTION!
Before doing a read/write buffer test, make sure that the adapter does not
have any outstanding I/O operations.
–STOP
= Stop the test if a failure occurs.
–RWPAT n
= Set the pattern to write to the buffer, one of the following:
n = 1 (8 bytes of 0x55h) (default)
n = 2 (8 b.0tes of 0x5Ah)
n = 3 (16 bytes of 0xAAh)
n = 4 (16 bytes of 0xFFh)
hba_port_inst = The adapter port tested.
-CNT
= Used with Test Count to set the number of tests, with one test
as default.
Test Count = The number of tests to do, with one as default. Type a num-
ber between 2–(2 31 ) for more than one test.