Safety
12
UM-PRORUNNER_mk9-2.0-EN
3.3.2
Set up
•
Connect the machine in accordance with the local laws and regulations concerning
health and safety.
•
Before putting the machine into use, check if the machine has been set up in
accordance with the instructions in this manual and with the layout drawing.
•
Make sure that the transport system complies with all relevant health and safety
directives and regulations.
3.3.3
Start the machine
•
Do not switch the main power supply on when persons are in contact with the
machine.
•
Do not start the machine when persons are in contact with the machine.
•
Do not start the machine when persons are present in the fenced area of the machine.
•
Before the machine is put into operation, all machine parts must comply with all
relevant health and safety directives and regulations.
3.3.4
During machine operation
•
Keep your hands and feet away from the fenced area.
•
Make sure you do not wear loose clothing and secure long or loose hair.
•
Make sure that no persons or objects are within the range of any moving parts of the
machine.
•
Make sure that users know and observe all safety rules with regard to the machine
and the environment in which it operates.
3.3.5
Maintenance and repair
•
Turn off the power supply to the machine with the main power supply switch before
starting any maintenance or repair tasks. Secure the main power supply switch in the
off position with a padlock.
•
Replace damaged or defective parts before putting the machine back into operation.
•
Changes and modifications that may affect the safety of the machine can only be
carried out when these changes and modifications comply with the relevant
regulations, legislation, directives and recognized industry standards.
If changes and modifications are outside the scope of specifications given by Qimarox
in this manual and Qimarox has not granted permission changes and modifications,
then the changes and modifications will entirely be the responsibility of those persons
responsible for carrying out the changes and modifications.
•
Electrical installation tasks must only be carried out by qualified personnel.
3.4
Safety equipment
•
You must not disassemble, bypass or disable any safety equipment on the machine.
•
The machine may not be started and must be immediately taken out of operation if
even a single item of machine safety equipment is defective.
•
After maintenance tasks are complete, always replace all safety equipment that has
been removed from the machine.
The machine has been equipped with the following safety equipment:
•
Safety pressure valve (pneumatic system for mechanical locking device)
•
Mechanical locking device
•
Panels on the backside of the machine
