Qimarox PRORUNNER Mk5, Руководство пользователя

Страница: 88 / 202

Maintenance RollerDrive conveyor
88 UM-PRORUNNER_Mk5-1.2-EN-US
8.3 Cleaning
1. Switch off the machine.
2. Secure the main power supply switch with a padlock.
3. Remove deposit and dirt by hand.
4. Report any damage to the technically responsible person or to Qimarox and make
sure that any damage is remedied before restarting the machine.
8.4 Check the drive roller
1. Replace the drive roller if it is damaged or making running sounds.
8.5 Check the rollers
1. Replace the roller if it is damaged or making running sounds.
8.6 Check the belts
The belts will elongate with use. How fast this happens depends on the conditions of use.
Belts elongate the most after the machine has been put into operation for the first time.
A belt with insufficient tension will slip and may not convey the product properly. Slipping
belts must be replaced.
8.7 Replace parts
Some machine parts are subject to wear. See the type plate and the exploded view for the
specifications of the machine parts.
DANGER
Do not use any corrosive and inflammable solvents or cleaning agents on the
machine that contain TRI, PER, TETRA or FCHC. Read the instructions on the
packaging when use is made of chemical substances (cleaning agents).
WARNING
•
Electrical components should not make contact with water or other liquids.
•
Do not clean the machine with compressed air or water under high pres-
sure.
•
Avoid parts made of rubber or plastic, such as cables and gaskets, from
making contact with oil, solvents or other chemicals.
WARNING
Replace parts only with parts supplied or recommended by Qimarox.
If parts are not replaced with supplied or recommended Qimarox parts, the
machine warrantee becomes null and void. Refer to section
2.3 .