Operating
screens
74
Operating manual HR9
– QS21XXXX
Manual mode
It is possible to perform manual operations on the machine / installation.
The machine is divided into different sections. A specific section can be selected to operate
this. It is also possible to scroll through the manual screens using the ‘Previous’ and ‘Next’
buttons.
The following applies to the manual controls:
-
In case of air movements, the button to perform manual controls needs to be pressed
once.
-
Movement with position controlled motors is allowed until the minimum or maximum
position is reached.
-
With motors, the button must be held to perform the movement. When the button is
released, the motor also stops moving. The only exception to this is the referencing
(homing) of position-controlled motors. As soon as the homing (referencing)
movement has started, it will be executed until the homing has been completed. You
therefore do not have to hold down the button for this.
INFO
This menu can always be reached and viewed. However, manual operation is
only possible if the machine is in ‘MANUAL’ mode and state is set to
‘EXECUTE’
If you are in one of the manual control screens, you can always return to the overview above
by pressing the
button.
Press the part of the installation where you want to perform the manual operation. Or use the
tabs to go to the correct machine part!!
