QHYCCD QHY90A, Руководство пользователя

Страница: 13 / 29

QHY90A
13
05 Use QHY90A in EZCAP_QT
EZCAP_QT (
V0.1.51.18
) is a software made by QHYCCD. This software has both windows, linux and
MAC/OS version. This software created with the opensource QT software. This software can be modified
if you want the source code. It has the basic capture function and working in single frame mode.
1. Install EZCAP_QT software.
2. Connect your QHY90A to 12V power supply. Connect your QHY90A to your computer with USB3.0 cable.
3.
Run EZCAP_QT. Select “Connect” in Menu->Camera. If the camera is successfully connected. The title
of EZCAP_QT will display the camera firmware version and the camera ID as shown below
You can change the language of the softwre at menu->language.
4. Before you click "connect", make sure you can see QHY90A in the device manager on Windows. Sometimes
if you click "connect", you may see the warning shown in the picture below.
That doesn't necessarily mean that the camera and your computer are not connected. In this case, you
can just wait for a minute and click 'connect' again, then you can see it will be connected successfully.
This is because it usually takes a while to load its firmware into your computer.
5. In Menu->Camera Setup, Click "Temp Control" and set the CCD sensor temperature. You can enable the
"Auto Control" and set the target temperature. For example here we set the temperature to -10C. The CMOS
temperature will come to -10C very fast (in about 2-3minute). If you want to close the TEC, you can select
"TEC OFF". If you just want to set the TEC power but not the temperature. You can select "Manual" and then
set the percent of the TEC power.