QHYCCD QHY600, Руководство пользователя

Страница: 7 / 27

QHY600
7
05 Description of Earth Interface
One back case of the QHY600, There is the USB3.0 port, 4PIN QHYCFW port, 12V power input port and
two 10 Gigabit Optic Fiber port
（
Professional version and early bird version only)
One side of the camera front part, there is a silicone gel tube socket. Normally it is filled with a screw with
the O-ring. If the CMOS sensor chamber need to be dry, you can connect the silicone gel tube and make
sure the silicone gel tube filled with the effective silicone gel. If you are using the gel without package, you
need to install a small cotton to avoid the gel enter to the CMOS chamber
06
Use QHY600 in SharpCap
1. Copy the lastest QHYCCD SDK to the SHARPCAP folder to replace the old one), For 32bit
SharpCAP, just copy and overwrite it. For 64bit SharpCAP, you need to copy the qhyccd_x64.dll and rename
it to qhyccd.dll to overwrite the old one.
2. Connect the QHY600 to the 12V power supply and connect your QHY600 to the computer using the
USB3.0 data cable.
3. Turn on SharpCap. If the software and drivers mentioned above are installed successfully, the video
image will appear automatically in about 3sec after the software begin to working, and you can also see the
frame rate in the lower left corner of the software, as shown below.
4. If you have already started the SharpCap software before connecting the camera, in order to open the
camera, you can click on the camera in the menu bar and then select QHY600.
5. Offset adjustment, when you completely block the camera, you may find that the image is not really