24
– 05|2016 – Subject to change.
KidGoo1 – Q8000-S
Utilisation
Below you will find all the information for adapting the
KidGoo1
to the required modes and to
allow you to use all the convenience functions.
Operating the brake
The disc brake system of the
KidGoo1
is used as a parking brake but is also used for braking during
the journey in the buggy and walker mode. It is operated centrally using the lockable brake lever
in the middle of the push handle.
Danger!
When it is stationary, secure the
KidGoo1
in order to prevent it from rolling away by
applying the brake. Also remember to release it before you set off.
Braking during the journey
The brake can help you to manage downhill slopes in buggy and walker mode. Braking and the
strength of the braking effect work in the same way as the brake lever of the bicycle handlebar.
f
Pull the brake lever towards the push handle to decelerate the
KidGoo1
.
f
Release the brake lever to loosen the brake.
Using the parking brake
Activate the parking brake when standing by pulling the brake lever and locking it.
f
Pull the brake lever close to the push handle until the
locking pin can be pushed down.
f
Push the locking pin down fully and release the brake
lever. The locking pin keeps the brake under tension.
Danger!
Always check if the braking effect is sufficient. Adjust the brake immediately if you can
push the
KidGoo1
when the parking brake is applied.
f
To release the parking brake, pull the brake lever
towards the push handle again.
f
As soon as locking pin jumps upwards, you can
operate the brake as normal.
