QEP 83240, Руководство пользователя

Страница: 9 / 12

- 8 -
MAINTENANCE
WARNING! Disconnect the power supply before making adjustments or maintenance on the machine! Never use
water or chemicals while cleaning electrical parts of the machine.
A. Periodic maintenance of the saw will reduce unnecessary problems. Use soft cloth to clean the water and dust
on the machine.
B. Keep the ventilation slots of the saw clean to prevent overheating of the motor.
C. Dry the saw as much as possible after using.
WARNING: Disconnect the POWER CORD from the main socket BEFORE doing any maintenance!
It is recommended that the pump be disassembled and cleaned at the end of each day. Dust and debris can dry
and cause the pump to “freeze”. If your pump will not operate, clean it thoroughly.
DO NOT CLEAN WHILE THE POWER IS CONNECTED!
1. Pump maintenance: (FIG. 22)
A. Remove the Pump Intake cover; then remove the Foam Filter.
B. Remove the Impeller cover, and remove the impeller.
C. Flush the inside of the Pump, the Impeller, and the Foam Filter with CLEAN Water.
D. Reassemble the pump, If the filter cannot be cleaned, or there is excess debris, use a new filter
2. Replace the filter foam
To replace the filter foam, remove the inlet cover, then take out of the filter foam and put into a new one.
3. Replace the pump
After replacing the filter foam, if the pump does not work, you must replace it with a new pump, only use the pump
recommended by the manufacturer of the machine. The changing procedures is as follows:
(1) Take out of the water tray, and there is a connecting box on the left inside the frame (FIG. 23-1).
(2) Unscrew the nut on the connecting box and remove the cover (FIG. 23-2)
(3) Disconnect the plug from the socket (FIG. 23-3), and loosen the nut connecting the pump with the
pipe (FIG. 23-4).
(4) Then replace the old pump with a new one, and reverse the procedures (1) to (3).
TROUBLE SHOOTING
Listed below is a number of possible causes and corresponding solutions in case the machine does not function
as it should:
A. The motor gets hot
1. The ventilation slots in the motor are blocked with dirt
-Clean the cool ventilation slots
2. The motor is defective
-Have your machine repaired by your supplier
B. The machine does not work
1. Check the electrical connection
2. The switch is broken
-Have your machine repaired by your supplier
ACCESSORIES
1. Fold-out stand with wheels
2. 10" continuous rim wet diamond blade (#6-1003CR)
3. High volume water pump (#60098)
4. Laser cutting guide
5. Side extension table
6. Angle cutting guide
7. Handles