QEP 61900Q, Руководство пользователя

Страница: 23 / 32

23
MAINTENANCE
Do not service, clean or maintain the saw without
first turning off the motor and unplugging the saw
from the power source. Failure to do so may result
in serious personal injury.
repLACING CArBON BrUSHeS (FIG. rr)
NOTE:
replace both carbon brushes when either has less
than 1/4 in. length of carbon remaining, or if the spring or
wire is damaged or burned.
•
To inspect or replace brushes, first unplug the saw.
• Loosen the blade elevation locking knob (1) to raise
the cutting head at the maximum height. tighten the
blade elevation locking knob.
•
Loosen the blade tilting locking knob (2) to tilt the
cutting head at 45° clockwise. tighten the blade
tilting locking knob.
• then, remove the black plastic cap (3) on the side of
the motor. remove the cap cautiously, because it is
springloaded. Pull out the carbon brush and replace.
•
the ears on the metal end of the assembly go in the
same hole the carbon part fits into. Tighten the cap
snugly, but do not overtighten.
• repeat for the carbon brush located on the other side
of motor.
NOTE:
To reinstall the same brushes, first make sure
the brushes go back in the way they came out. this will
avoid a break-in period that reduces motor performance
and increases wear.
WARNING
!
Fig. rr
1
2
3
3
CLEANING
• insert the water pump into a bucket of clean water
and pump the water through the hose.
• turn off and unplug the saw from the power source.
•
Place a bucket under the drain plug. remove
the drain plug and allow the water to empty into
the bucket.
• Slide the edge guide off the rail system. Spray the
rip/angle guide with a hose or wipe with a grout
sponge or clean cloth.
•
Wipe the cutting table, motor housing, and motor
support arm with a grout sponge or clean cloth.
Spray lubricants are not required on the rail or
cutting blade.
•
remove all water catch trays and clean the water
trays by spraying with a hose or wiping with a grout
sponge.
use clean cloth to remove dirt, dust, oil, grease, etc. do
not use gasoline, turpentine, lacquer or paint thinner,
dry cleaning fluids or similar products. Chemicals can
damage, weaken or destroy plastic which may result in
personal injury.
try not to let any liquid get inside the tool; never
immerse any part of the tool into a liquid.