QEP 61900Q, Руководство пользователя

Страница: 19 / 32

19
OPERATION
BeFOre USING THe TILe SAW
To avoid mistakes that could cause serious,
permanent injury, do not plug the tool in until the
following steps are completed:
•
Completely assemble and adjust the tile saw,
following the instructions. (See ASSeMBLY AND
ADJUSTMeNTS SeCTIONS).
•
review and understand all safety instructions and
operating procedures in this Operator’s Manual.
(See SAFeTY & OperATIONS SeCTIONS).
•
review the MAINTeNANCe and
TrOUBLeSHOOTING GUIDe for your tile saw.
•
To avoid injury or possible death from electrical
shock, make sure your fingers do not touch
the plug’s metal prongs when plugging or
unplugging your tile saw. (See eLeCTrICAL
reQUIreMeNTS AND SAFeTY SeCTIONS).
BASIC SAW OPERATIONS
WARNING
!
•
Overfilling the water basin can lead to water
entering the motor compartment and potential
electric shock.
•
When filling/draining water basin, make sure wet
tile saw is unpluged from wall outlet.
LeD LIGHT ON/OFF SWITCH (FIG. FF)
•
to turn the Led light on, press light on/off rocker
switch (1) to “i” position.
•
to turn he Led light off, press light on/off rocker
switch (1) to “o” position.
ON/OFF SWITCH (FIG. FF)
the on/off switch has a black removable safety key.
With the key removed from the switch, unauthorized and
hazardous use by children and others is minimized and
the saw will not turn on.
• to turn the saw "on", insert the key (2) into the slot
of the switch (3), and move the switch upward to the
"on" position.
•
to turn the saw "off", move the switch downward.
• to lock the switch in the off position, grasp the
sides of the safety switch key, and pull it out.
• With the switch key removed, the switch will not
operate to power the saw on.
WARNING
!
•
if the switch key is removed while the saw is
running, it can be turned "off" but cannot be
restarted without inserting the switch key.
ALWAYS lock the switch “OFF” when the tile saw
is not in use. remove the key and keep it in a safe
place. In the event of a power failure, blown fuse, or
tripped circuit breaker, turn the switch “OFF” and
remove the key, preventing an accidental startup
when power comes on.
USING THe rIp/ANGLe GUIDe (FIG. GG)
NOTE:
the miter scale on the rip/angle guide can be
easily read, showing miter angles from 0° to 45° to the
left and the right. the positive stops are 0°, 15°, 30° and
45°.
•
Loosen the locking handle (1) to move the guide
along the front rail to the desired position and
handle.
•
Loosen the locking knob (2) to turn the guide to the
desired angle along the arc slot (3) and then tighten
the locking knob (2).
Fig. FF
1
2
3
WARNING
!
Fig. GG
1
2
3