QEP 61900Q, Руководство пользователя

Страница: 15 / 32

15
To prevent personal injury:
•
Always disconnect plug from the power source
when making any adjustments.
•
This adjustment must be correct or accurate cuts
can not be made. Also inaccurate adjustment
can result serious personal injury.
TrUING (SQUArING) THe CUTTING BLADe
(FIG. U, V)
Checking the cutting blade alignment (Fig. U)
•
Place a 90° framing square flat on the cutting table
surface with one end against the table fence.
•
Push the cutting table along the cutting blade to
determine if the groove along the 90° framing square
is consistently flush against the blade throughout the
length of the stroke.
•
if the groove is not consistent, see the next steps.
Adjusting the cutting blade 90° to cutting table (Fig. U)
•
disconnect the saw from the power source.
• Loosen the blade tilting locking knob (1) and make
sure the cutting blade is in the maximum vertical
position. tighten the locking knob (1).
•
Place a 90° framing square on the cutting table
surface.
•
if the cutting blade is not 90° to the groove (2),
loosen the lock nut (3) with the 10 mm hex wrench
and turn the bolt (4) in or out accordingly. until the
blade is flush with the framing square, while moving
down the center of the groove.
•
Make sure that the cutting blade does not touch
either side of the groove (2) in the cutting table by
pushing the table past the cutting blade.
INSTALLING THe rIp/ANGLe GUIDe (FIG. T)
• Loosen the locking handle (1).
• Place the rip/angle guide body (2) on the front rail
(3) of tile table to the desired position.
• tighten the locking handle (1).
This saw was adjusted for accuracy at the factory.
During Shipping the components may have been
moved out of alignment. In addition, usage and time
will necessitate adjustments to be made.
1
2
3
4
1
3
2
5
4
6 5
Fig. r
7
8
5
Fig. S
Fig. T
1
2
3
Fig. U
WARNING
!
WARNING
!
framing Square