ENGLISH
25
Hardware Installation
Connect to Management Port
3.7
The switch has one management port. The management port is a dedicated port interface which
is segregated from data traffic crossing other downlink or uplink ports. The port supports auto-
negotiation. If the attached device also supports auto-negation, the transmission can operate in either
half or full duplex, and data rate can be in 10Mbps, 100Mbps, or 1000Mbps. Telnet, SNMP, and Web
browser utility can all go through this port for local or remote management after the IP address, subnet
mask, and default gateway are properly configured.
To connect to the management port, do the following:
Connect one end of an Ethernet cable to the management port.
1.
Connect to Management Port
Figure 3-11:
Connect the other end of the Ethernet cable to a network.
2.
The Management port LED (Link/Activity LED) lights green when the network link is established.
NOTE:
Ethernet cables are not included in the package. Contact your dealer to purchase.
