7
2 Device Overview
2.1 Device Overview
NOTE: For video tutorials on your Spy Cam DVR and its widget please visit:
2.2 Charging
The camera comes with an internal rechargeable battery. When using the camera for the first time, or if
you are using it after a long period of non-usage, remember to fully charge the battery for at least 8 hours
and to sync the time in the QSD-722 again by using the widget (see section
"PC Software Widget"
) if
needed. You can charge your camera by using the USB port of your computer, the DC adapter, or a car
adapter.
To charge the battery through a USB port, connect the USB cable to the USB port of the computer and the
camera. For details, please see the status below. The camera will function as a mass storage device. You
will not be able to record video during this time.
To charge the battery through a DC adapter or car adapter, connect the DC adapter or car adapter to the
camera. For details, please see the
Status
section below. Moreover, you will also be able to record video
while charging depending on the mode you set.
2.3 Recording
Recording
The power button is located at the right hand side of the camera. It functions to turn the camera on and off
for use and storage.
Start Recording
Press and hold the Power button until the green LED is on, and then release the button. When you see the
green LED flashing, the camera is recording. If you see otherwise, please read the Status section below.
Trigger in/out
Micro USB Port
PIR Sensor
Light Sensor
Microphone
Lens
Card Slot
Status LED Indicator
On/Off
Continuous
Triggering
Custom Mode
