q-Tech QSW-9010, Руководство по настройке CLI

Страница: 13 / 101

User Manual
1. GPON properties 13
www.qtech.ru
Configure NTP Server:
OLT(config)#sntp unicast-server 192.168.17.117
The source address used when sending synchronization request for connecting NTP:
OLT(config)#sntp connect 192.168.17.117
Configure the NTP synchronization interval, the time unit is seconds:
OLT(config)#sntp auto-sync timer 10
(Optional) Check the running status of NTP:
OLT# show sntp
Simple ntp client:
Status: Enable
Auto sync timer: 10s
Last sync time: Fri Nov 11 02:33:48 UTC 2016
Current time: Fri Nov 11 02:33:51 UTC 2016
Ntp server list:
192.168.17.117 Support Total: 1
After configuring the system time, the user can view the corresponding time in the command
line log and the alarm record in order to locate the fault.
Note:
The server re-connect after interruption in SNTP server, and the OLT state is unsupport, OLT will not
automatically synchronize the system time.
1.6. System time configuration
This command is used to set system time. Use this command when you need to set system time.
When the command succeeds, the system time becomes the set time.
Configure the timezone under global configuration mode:
OLT(config)#timezone gmt + 03:00
OLT(config)#exit
Configure the system time under administrator mode:
OLT#clock set 2016.05.31-11:02:30
(Optional) View the system time:
OLT(config)# show timezone
System timezone: gmt + 03:00
OLT# show clock
Address Service