Pyronix DECIBELL, Руководство по установке

Страница: 13 / 24

DECIBELL
RINS040-5 Page:
11
3. WIRING BELL TAMPER TO CONTROL PANEL ZONES
The examples below show how to connect the bell tamper to the Matrix 6 / 816 systems, this system
uses a zone as a tamper circuit.
If the alarm panel requires
end of line resistors , wire the DECIBELL as the below diagram.
Please note that the resistance value will change depending on the alarm panel (please refer to the
installation manual of that alarm system).
NO1 C1 NO1 PGM2 PGM3 PGM4 PGM5 PGM6 + AUX - K+ KD K- Z1 COM Z2 Z3 COM Z4 + AUX - Z5 COM Z6
Matrix 6 / 816
If the alarm panel is wired normally closed, wire the DECIBELL as the following:
NO1 C1 NO1 PGM2 PGM3 PGM4 PGM5 PGM6 + AUX - K+ KD K- Z1 COM Z2 Z3 COM Z4 + AUX - Z5 COM Z6
Matrix 6 / 816
EOL
Resistor