TIMETRAX SYNC™ COUNT UP/COUNTDOWN
DIGITAL TIMER CONTROLLER
Models CTPLATEBUZ/CBPLATEBUZ Instructions
888.479.7264
pyramidtimesystem.com
I2264 Rev. C
OVERVIEW
The
TimeTrax Sync™ Count Up/Down or Code Blue Controller
is used in conjunction with a
TimeTrax Sync™ Digital
Timer
(sold separately) to monitor elapsed or remaining time during critical events, educational testing/instruction,
manufacturing processes, lab testing, recreational activities, seminars, transportation depot applications, broadcasting and
other time-sensitive events. Features include a Start/Pause button to start or stop counting function. A built-in buzzer
signals the user when timer reaches zero in countdown mode.
Use Count Up/Countdown or Code Blue Controller with any of the following
TimeTrax Sync™ Digital Timer
models:
9D26BRCT, S9D2R6CALS, S9D4R6CALB, S9D2B6CALB, S9D2R6CAUB, S9D4R6CAUB, S9D2B6CAUB, S9D4B6CAUB.
TimeTrax Sync™ Digital Timers
may also be used in conjunction with a
TimeTrax Sync™ RF Wireless Transmitter
to
receive accurate, official time signal.
Connect RJ45 cable into port located in compartment on back of Controller switch plate.
Route the RJ45 cable through standard single gang electrical box (not included). Pull cable through wall
cavity and out to digital timer installation location.
Plug other end of RJ45 cable into port located in compartment on back of
TimeTrax Sync™ Digital
Timer
(sold separately). The Controller switch plate is able to control more than one Digital Timer.*
Wire TimeTrax Sync™ Digital Timer according to installation instructions.
CAUTION:
110V CLOCK WIRING SHOULD BE COMPLETED PER ELECTRICAL CODE AND PERFORMED BY A LICENSED ELECTRICIAN.
Before mounting controller switch plate to electrical box, push the buzzer volume test button located on
the back of switch plate in the top right hand corner.
To increase buzzer volume, turn blue volume control button clockwise using a flathead screwdriver. To
decrease buzzer volume or deactivate buzzer, turn blue volume button counter clockwise.
To enable “pulsating” buzzer sound, remove jumper from J2 and install jumper on J1.
Mount Controller switch plate to electrical box using two screws provided.
*Use RJ45 Y-Splitter (part no 41270) to daisy chain more than one digital timer.
INSTALLATION
